Routing With The Dante Controller - Monacor AKB-30DT/DSP Bedienungsanleitung

5.3 Routing with the Dante Controller

To assign the input signals and output signals of the corresponding
units:
1) Under "Routing" in the window "Network View", click
the channels of the desired unit under "Dante Transmitters" and
the channels of the AKB-30DT/ DSP under "Dante Receivers" (refer
to fig . 4) .
2) Navigate from the column of the Dante transmit channel to the
line of the desired Dante receive channel and click the field at the
intersection point .
3) Wait for the field to show a green circle with a white check mark ✔ .
4) Repeat the last two steps for the second Dante receive channel of
the AKB-30DT/ DSP, if required .
⊞
to open
Fig. 4 Audio routing from the audio source "VirtualSoundcard"
to the receiver "AKB-30DT-DSP"
An English user guide for the Dante Controller is available for down-
load on the Audinate website:
https://www .audinate .com/resources/technical-documentation
39