Groups Of Units - Monacor AKB-30DT/DSP Bedienungsanleitung

Note: The program "DSP Controller" is not only used to control amplifiers of the
type AKB-30DT/ DSP but also other units from MONACOR with integrated signal
processor . Therefore, the list also contains DSM-48LAN .
Description of functions:
1 . Button to mute the unit
When the unit is muted, the button is red . To unmute, click the
button again . Clicking the button
mute any units connected .
2 . Button to identify a unit
When this button is clicked, the button and all LEDs on the unit
will flash for a few seconds .
3 . Icon for the operating status of the unit
green = operation
red = standby
grey = connection interrupted
Click the icon to switch between operating mode and standby
mode . When the unit is switched on and a new connection is
being established, an additional line "Startup..." with the icon
will temporarily appear at the end of the list .
4 . The two vertical bars
the output of a unit .
5 . Indication of unit name
42
in the line "All Units" will
are basic level indicators for the input and
The preset name can be changed here or in the configuration menu
☞
( chapter 7 .3 .2) in order to distinguish between identical units . It
is advisable to use the name used in the Dante network .
6 . Indication of the hardware address (MAC address) of the interface
of the unit; this address will always clearly identify a unit
7 . Indication of the IP address of a unit
When the connection is interrupted, "Offline" is indicated here .
8 . Button to call up the configuration window (fig . 9) for a unit
which is "on line"
In the line "All Units", click the button
or click to show the list .

7.2.1 Groups of units

Multiple units can be combined in groups for controlling them together .
They may, for example, all be muted . The settings
define which parameters of the group will apply to all members of
this group . All actions of a group require the necessary access rights
for the group members .
There are three types of groups:
"Carbon Copy": All settings (except the parameters defined under
"Exceptions") in the configuration window of the
group or a group member will apply to all other
group members .
"Advanced": Only the settings of the parameters defined under
"Setup Links" will apply to the group members .
to hide the list of units
of the group