Herunterladen Inhalt Inhalt Diese Seite drucken

Mp3 Player With Remote Control (For The Model Txa-1020Usb Only) - Monacor TXA-1020 Bedienungsanleitung

Transportables high-power-verstärkersystem
Vorschau ausblenden Andere Handbücher für TXA-1020:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 1
1.1 MP3 player with remote control
(for the model TXA-1020USB only)
With the player, MP3 files
age media and SD / SDHC memory cards
can be replayed.
– Connect a USB storage medium
USB flash drive, USB hard disk with sep-
arate power supply) to the jack
– Insert an SD card or SDHC card
max.) into the slot SD / MMC CARD
(notched corner to the right and facing
the unit) until it engages. To remove the
card, push the card into the slot until it
disengages.
To switch the player on, keep the button
POWER pressed for approx. 1 second.
The player will immediately start the replay
once the sound carrier has been read. The
display will indicate the sound carrier
("USB" or "SD"), the folder number and the
number of the title in the folder (e. g.
= title 3 in folder 1). In the replay
mode and in the pause mode, the lower right
section of the display will indicate the time
already played of the title (hour : min. : sec.);
in the stop mode, it will indicate the total
playing time of the title.
Note: The titles will be replayed in the following
order: first, all titles without any folder in the root
directory (compiled by the player in folder 0), then
the first folder of the root directory with its sub-
folders, then the next folder of the root directory
with its subfolders, etc. (see following example).
To switch between two sound carriers con-
nected, remove the memory card or the
USB storage medium; the player will then
automatically switch to the other sound car-
rier.
The operating options can be found in the
table to the right.
1
The player also supports the reproduction of WMA
files.
2
Due to the large number of storage device manufac-
turers and device drivers, it cannot be guaranteed that
all storage media are compatible with this player.
10
Downloaded from
www.Manualslib.com
1
from USB stor-
2
(e. g.
.
2
(32 GB
Title A
Title B
Title C
...
The infrared remote control is supplied
with a battery. Prior to initial operation,
remove the foil from the battery holder.
When pressing a button, always point the
remote control to the infrared sensor
(above the USB port). Make sure that there
are no obstacles between the sensor and
the remote control.
If the remote control is not used for a
longer time, remove the battery as a pre-
caution so that the remote control will not
be damaged in case the battery should
leak.
When the operating range of the remote
control decreases, the battery is dis-
charged and must be replaced: On the rear
side of the remote control, push the small
latch with the groove to the right (first arrow
manuals search engine
Functions of the buttons
Buttons at the player
To switch the player on and off (keep the button pressed for approx. 1 sec.)
– in the stop mode and in the pause mode:
= go to the next title,
= go to the previous title.
Then the replay of the title will be immediately started.
– during replay: to reduce ( ) or increase (
To stop the replay and to return to the beginning of the title
To pause and continue the replay
– in the stop mode and in the pause mode: to select the folder
Press the button (folder indication starts flashing). Then select the folder with the
button
or
and confirm with the button
The first title of the selected folder will be started.
– during replay: to select the replay mode
The following replay modes are available:
=
all titles of the folder continuously repeated
=
all titles of the sound carrier continuously repeated
=
current title continuously repeated
Press the button repeatedly until the symbol for the replay mode desired starts
flashing, and then press the button
Note: The player will exit the selection mode after 5 seconds if no button is pressed.
Buttons on the remote control
To select a title within a folder: Enter the number that the title has within the folder, and
then press the button
.
To reduce (VOL-) or increase (VOL+) the volume
– press briefly: title selection (
= forward,
– keep pressed: fast forward (
), fast reverse ( )
To pause and continue the replay
To mute and unmute the sound
(The sound can also be unmuted by pressing one of the VOL buttons.)
– to select the folder
Press the button once (folder indication will start flashing). Then, to select the folder,
either use the button
or
or enter the folder number with the numeric keys. Then
press the button
to confirm: The first title in the folder selected will be started.
– to select the replay mode
Press the button repeatedly until the symbol for the replay mode desired starts
flashing (three replay modes available
and then press the button
to confirm.
Note: The player will exit the selection mode after 5 seconds if no button is pressed.
To stop the replay and to return to the beginning of the title
) the volume.
:
to confirm.
= reverse)
button REPEAT/ FOLDER at the player),
in the following figure) and remove the bat-
tery holder (second arrow). Remove the
discharged battery and insert a new 3 V
button cell of the type CR 2025 with the
positive pole showing upwards into the
holder. Then insert the holder into the
remote control.
Batteries must not be placed in
the household waste. Always take
them to a special waste disposal,
e. g. collection container at your
retailer.

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

Txa-1020usb

Inhaltsverzeichnis