Cameo CLOFW Bedienungsanleitung Seite 14

OPERATION / BEDIENUNG / UTILISATION / OPERACIÓN / OBSŁUGA / UTILIZZO
EN
When the spotlight is properly connected to the mains, the motors are reset. Within a few seconds, the spotlight is ready for use and changes to
the mode that was previously selected.
SELECTING THE DMX START ADDRESS
Press the MODE button repeatedly until "Addr" appears on the display. Press ENTER, and while all four characters are flashing on the display, the
DMX start address can be set as desired using the UP and DOWN buttons (A001 - A512). Confirm the input with ENTER. The synchronous control of
multiple spotlights (same model) through a DMX control unit (e.g. DMX mixer) can be achieved by assigning the spotlights to an identical DMX start
address and DMX mode and connecting them using DMX cables.
ADJUSTING THE OPERATING MODE
Press the MODE button repeatedly until "MOdE" appears on the display. Press ENTER, and while all four characters are flashing on the display, the
operating mode can be set as desired using the UP and DOWN buttons (3Ch, 6Ch, 14Ch, SLAV, AUTO, SOUn). Confirm
the input with ENTER. You will find tables with the channels of the different DMX modes on the following pages of this manual.
SLAVE MODE
Connect the slave and the master unit (same model) with a DMX cable and activate one of the standalone modes on the master unit. Now the slave
unit follows the master unit.
AUTOMATIC CONTROL MODE (AUTO)
Choose one of the 25 different auto programs (AU01 - AU25), one of the two TILT motion patterns (PA01 - PA02) and the running speed (SP01 - SP99)
of the LED sequences and the movement patterns.
-> ENTER ->
AUtO
<- MODE
(=Master)
MUSIC CONTROL (SOUND)
Select the Music control mode, to control the spotlight via the built-in microphone. Set the microphone sensitivity (SE01 - SE99) as required and
select one of the two TILT motion patterns (PA01 - PA02).
-> ENTER ->
SOUn UP/DOWN
<- MODE
(=Master)
SYSTEM SETTINGS AND SYSTEM INFORMATION
To be able to adjust or read system settings and information, press the MODE button repeatedly until "SEtt" appears on the display. Confirm with
ENTER. While all four characters are flashing on the display, one of the following menu items can be set as desired using the UP and DOWN buttons.
14
-> ENTER ->
UP/DOWN AU01 - AU25
<- MODE
-> ENTER ->
SE01 - SE99
<- MODE
(Sensitivity min.
- max.)
UP/DOWN PA01 - PA02
(Tilt Movement
Pattern 01 - 02)
UP/DOWN PA01 - PA02
(Tilt Movement
Pattern 01 - 02)
-> ENTER ->
UP/DOWN SP01 - SP99
<- MODE
(LED Sequence
+ Movement
Pattern Speed)
-> ENTER
<- MODE
-> ENTER
<- MODE