Installation Instructions - Dentsply Sirona inLab Speedcure 9494800 Bedienungsanleitung

INSTALLATION INSTRUCTIONS

Shipping damage should be reported to the carrier as soon as detected.
The unit package contains the following:
• 1 - Instruction Manual (this document)
• 1 - inLab Speedcure Processing Unit
• 2 - Spare Bulbs
• 1 - Turntable
• 1 - Gloves (pair)
• 2 - 10A Fuse (220-240V only)
UNPACKING NOTE: Save the box and packing materials for future use when transporting the unit.
• Open the box.
• Remove the accessory kit.
• Carefully remove the unit from the box by lifting the packaging supports - lift metal base only. Support
unit from the bottom to prevent slipping. DO NOT LIFT UNIT USING PLASTIC SIDE COVERS.
• Remove packaging supports.
• Remove plastic bag.
• Remove remaining packaging material on the outside of unit.
• Remove turntable from the top of unit.
INSTALLATION
• Carefully place the unit on a solid flat surface. Position the unit at least 10cm (4 inches) from the wall or
other structures to allow for good airflow.
• Connect unit to a grounded power source.
• Open door and install turntable onto motor shaft, match flat sides of shaft and turntable.
WARNING:
Never operate the unit in close proximity to combustible materials or place materials on top of the unit.
Do not use extension cords with this equipment.
Plug the power cord into a circuit rated a minimum of 15A (120V) or 10A (220-240V).
Do not position the unit in a way that blocks access to the wall outlet or the powercord inlet socket.
Do not position the appliance(s) in a way where there is direct contact with a bulb.
3