SAFETY
Please read these operating instructions carefully before installing or operating this equipment.
•
Use indoors only.
•
Never operate the unit in close proximity to combustible materials or place materials on top of the unit.
•
The unit must be electrically grounded to a three-wire electrical outlet or receptacle. The electrical service
provided must be a dedicated line of the proper size according to local electrical codes.
•
Unit must be placed in a position that allows the power cord to be easily disconnected from the wall.
•
Do not attempt to service the unit until you have read and understand this instruction manual.
•
Turn off the power switch and disconnect the power cord before attempting to service the unit.
•
Do not operate the unit controls with tongs or other tools.
•
Do not use solvents or liquid cleaners on the control panel.
•
Do not touch the bulbs when the unit door is open.
•
Before replacing bulbs, allow the unit to cool to room temperature to avoid burns.
•
Do not cover the top of the unit or obstruct the rear fans in anyway.
•
Do not heat water or food in the unit chamber.
•
Do not submerge the unit into any liquid.
•
Do not store flammable products or solvents inside the unit chamber.
•
Follow the manufacturer's instructions for use for maximum appliance load per process and cure cycle.
•
If the unit is not operated in the manner as specified in this manual, the protection provided by the unit
may be impaired.
•
Pollution Degree: 2
!
CAUTION: RISK OF DANGER! BURN HAZARD IS PRESENT WHEN COVER IS OPENED.
USE CAUTION AFTER OPENING COVER, BULBS AND METAL SURFACES MAY BE HOT!
USE HEAT-RESISTANT GLOVES WHEN REMOVING BULBS!
Alternating current
I
On (Power Switch)
O
Off (Power Switch)
Caution, Hot Surface
Protective Conductor
!
Caution, Risk of Danger
High Intensity Light
Dispose of in accordance with the Waste Electrical and Electronic Equipment Directive
2012/19/EU of the European Parliament and the Council of the European Union
FOR PROFESSIONAL USE ONLY.
SYMBOL TABLE
1