User Maintenance; Bulb And Filter Replacement - Dentsply Sirona inLab Speedcure 9494800 Bedienungsanleitung

USER MAINTENANCE

WARNING:
This equipment contains dangerous voltages. Maintenance and repair work should only be
performed by an authorized service technician of Dentsply Sirona.
To keep the equipment in good working order follow the guidelines below.
• Examine the equipment regularly for mechanical damage.
• Make sure the lift is not obstructed in any way.
• Do not overload the table (1 lb. max), this can cause the motor to turn slower and cause wear on the
bearings.
• Do not attempt to manually force the lift when unit is powered up. This may result in motor damage.
CLEANING
• Clean the unit at least once a week.
• Clean exterior surfaces with a soft, damp cloth using a mild detergent and water.
• Clean the fan and exhaust vents, using low pressure compressed air, once a month or as needed to
prevent overheating.
• Do not use solvents or liquid cleaners on the control panel; they could enter the panel and cause damage.
• DO NOT IMMERSE IN WATER!

BULB AND FILTER REPLACEMENT

CAUTION:
!
TURN OFF THE POWER SWITCH AND UNPLUG UNIT FROM THE WALL OUTLET BEFORE
PERFORMING ANY MAINTENANCE ON THE UNIT.
CAUTION:
!
RISK OF DANGER! BURN HAZARD IS PRESENT WHEN COVER IS OPENED.
USE CAUTION AFTER OPENING COVER, BULBS AND METAL SURFACES MAY BE
HOT! ALLOW UNIT TO COOL AT LEAST 15 MINUTES BEFORE SERVICING. USE HEAT RESISTANT
GLOVES WHEN REMOVING BULBS!
NOTE: ALLOW THE UNIT TO COOL COMPLETELY BEFORE REPLACING BULBS TO ELIMINATE BURN
HAZARDS.
When a lamp is burned out, its location number will flash on the display. In the picture below, L2 is burned
out. Follow the instructions on the next page for bulb replacement. ONLY USE REPLACEMENT BULBS
SUPPLIED BY DENTSPLY SIRONA.
10