Installing A Hi-Speed Usb 2.0 Hub - Belkin F5U508 Handbuch

Installation

Installing a hi-speed usb 2.0 hub

Note: During installation of the Belkin Hi-Speed USB 2.0 and FireWire PCI Card
driver, a Hi-Speed USB 2.0 hub driver is also installed. When you attach a
Hi-Speed USB 2.0 hub to your PCI Card for the first time, follow the procedure
described below.
1. Turn on your computer.
EN
2. Plug the power adapter (ships with the hub) into the hub and into a wall
3. Connect the flat end of the USB cable supplied with the hub to your
4. Windows will automatically detect the hub and start the "Add New
5. Choose "Search for the best driver for your device (Recommended)". Click
6. Windows will now search the driver database on your hard drive. Remove
7. Windows will locate the driver for "Generic USB Hub on USB 2.0 Bus". Click
8. Click "Finish". Installation of your hub is now complete.
22
5248ea-A_F5U508ea.indb 22
outlet.
computer and the square end of the cable to the upstream port of the hub.
Hardware Wizard". The Wizard will search for drivers for a "Generic USB
Hub on USB 2.0 Bus". Click "Next". (If the search results list drivers for a
"Generic USB Hub" instead, cancel the Wizard, go back to Device Manager,
and confirm that the Belkin 2.0 drivers have been properly installed.)
"Next" to continue.
the check mark from all boxes and click "Next".
"Next".
14/2/07 9:08:52 am