Belkin F5U508 Handbuch Seite 24

Installation
6. Remove the port cover that corresponds with the PCI slot you wish to use.
7. Insert the PCI Card into the slot. Apply pressure as needed until the Card is
8. After installing the PCI Card, replace the outer cover and turn on the
9. When Windows restarts, the PCI Card will be detected and drivers for
EN
Note: Depending on the speed of your computer, it may take up to 45 seconds
for the PCI Card to be detected.
10. Windows will now search for drivers for the "ALi PCI to USB Enhanced
11. Drivers for the "Ali PCI to USB Enhanced Host Controller" will now be
12. Windows will now detect the "USB 2.0 Root Hub Device". Select "Install
13. Drivers for the "USB 2.0 Root Hub Device" will now be located. Click
14. Windows will now present you with the option of setting up a network.
20
5248ea-A_F5U508ea.indb 20
(The cover is usually held in place with a single screw).
fully seated. Secure the PCI Card with the screw removed in step 6.
computer.
the IEEE 1394 host controller, the IEEE 1394 net adapter, and two USB
OHCI host controllers with their associated root hubs will be automatically
installed.
Host Controller" and the "New Hardware Wizard" will start. Select "Install
the software automatically (Recommended)". Click "Next".
located. Click "Finish".
the software automatically (Recommended). Click "Next".
"Next". Then on the following screen click "Finish".
If you do not wish to set up an IEEE 1394 network, ignore this option.
(Please check your Windows XP help file for more information on setting
up and using an IEEE 1394 network).
The installation procedure is now complete.
14/2/07 9:08:52 am