Installation Procedure For Windows Me - Belkin F5U508 Handbuch

Installation

Installation Procedure for Windows Me

This installation procedure will successfully install two USB 1.1 OHCI
controllers, one USB 2.0 EHCI host controller, and one IEEE 1394 host
controller.
1. Insert the F5U508 installation CD into your CD-ROM drive. After a few
EN
2. Select "Install USB 2.0 Driver". After clicking "Next" on the InstallShield
3. Open the Start menu in the lower, left-hand corner of your Windows
4. Once the computer has completely shut down, remove the computer's
5. Remove the port cover that corresponds with the PCI slot you wish to use.
6. Insert the PCI Card into the slot. Apply pressure as needed until the Card
7. After installing the PCI Card, replace the outer cover and turn on the
8. When Windows restarts, the PCI Card will be detected and installation of
Note: Depending on the speed of your computer, it may take up to 30 seconds
for the PCI Card to be detected.
8
5248ea-A_F5U508ea.indb 8
moments, the main menu will automatically start and display each of the
available installation options.
Wizard, select "No, I will restart my computer later". Then click "Finish".
Then "Exit" on the F5U508 screen.
display. Select "Shut Down" and click "OK".
cover and locate an empty PCI slot.
(The cover is usually held in place with a single screw).
is fully seated. Secure the PCI Card with the screw removed in step #5,
above.
computer.
the required drivers will begin.
14/2/07 9:08:50 am