Installation Procedure For Windows Xp - Belkin F5U508 Handbuch

Installation Procedure for Windows XP

This installation procedure will successfully install two USB 1.1 OHCI
controllers, one USB 2.0 EHCI host controller, and one IEEE 1394 host
controller.
If you are running Windows XP with Service Pack 1, all required drivers are
already included in your operating system. It is not necessary to install the
drivers included on the F5U508 installation CD.
To confirm which version of Windows is installed on your computer, right-
click the "My Computer" icon located on your Windows desktop, then select
"Properties".
The "System Properties" window will open and provide information regarding
the version of Windows installed on your computer. If Windows "Service
Pack 1" or later is not installed, you must install the drivers provided on the
F5U508 installation CD.
If you find that Windows XP "Service Pack 1" is installed, follow the steps
below.
1. Open the Start menu in the lower, left-hand corner of your Windows
2. Once the computer is completely shut down, remove the computer's cover
3. Remove the port cover that corresponds with the PCI slot you wish to use.
5248ea-A_F5U508ea.indb 17
display, then select "Shut Down" and click "OK".
and locate an empty PCI slot.
(The cover is usually held in place with a single screw).
Installation
14/2/07 9:08:51 am
EN
17