Installing A Hi-Speed Usb 2.0 Hub - Belkin F5U508ea Bedienungsanleitung

P73954ea-A_F5U508ea_uk 28-03-2003 14:27 Page 17

INSTALLING A HI-SPEED USB 2.0 HUB

Note: During installation of a Belkin Hi-Speed USB 2.0 PCI Card driver, a
Hi-Speed USB 2.0 Hub driver is also installed. When you attach a Hi-
Speed USB 2.0 Hub to your PCI Card for the first time, follow the
procedure described below.
1. Turn on your computer.
2. Plug the power adapter (ships with the hub) into the hub and into a
wall outlet.
3. Connect the flat end of the USB cable supplied with the hub to your
computer and the square end of the cable to the upstream port of the
hub.
4. Windows will automatically detect the hub and start the "Add New
Hardware Wizard". The wizard will search for drivers for a "Generic USB
Hub on USB 2.0 Bus". Click "Next".
(If the search results list drivers for a "Generic USB Hub" instead,
cancel the wizard, go back to Device Manager and confirm that the
Belkin 2.0 drivers have been properly installed.)
5. Choose, "Search for the best driver for your device (Recommended)".
Click "Next" to continue.
6. Windows will now search the driver database on your hard drive.
Remove the check mark from all boxes and click "Next".
7. Windows will locate the driver for "Generic USB Hub on USB 2.0 Bus".
Click "Next".
8. Click "Finish". Installation of your hub is now complete.
17
En