Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
20
Attention:
Please note that after a successful update to a new firmware version, the Unite transmitters /
receivers are no longer compatible with older firmware versions.
5.5
Reset factory settings of the charger
• If you want to restore the factory settings of the charger, press the "Reset" button on the rear of the charger.
The charger will restart and restore the factory settings.
A reset restores the following information:
– DHCP Setting back to "Use DHCP"
– Static IP address back to default setting 192.168.1.101
– Static Subnet mask back to default setting 255.255.255.0
– Static Gateway back to default setting 192.168.1.1
– Delete/deactivate the individually stored settings of the mobile devices (portable devices, i.e. bodypack,
–
handheld).
– Deleting the stored pairing information
– Restoring the factory settings does not delete the pre-installed firmware update images!
5.6
Service mode
•
For maximum operational safety, the Unite Cockpit charger is equipped with a so-called service mode.
•
This means: If the device is disconnected from the mains within 15 seconds of being switched on (e.g.
by accidentally switching it off), the device starts in a service mode and checks itself. This takes about
1 minute and is indicated by a red operating display
desktop charger then returns to the normal operating mode. This is indicated by a green operating
display.
Unite CDD | CDS Cockpit Charger | Unite DS Basic Charger
on the rear of the charger. The Unite cockpit
Werbung
Inhaltsverzeichnis
