Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
18
5.4
Charging
1.
If pairing is not required and you only want to charge the transmitter and receiver, place the
transmitters and receivers in the appropriate charging compartments without activating the pairing
process via the "Pair/Reset"
If the stored pairing information is no longer needed, you can also delete it by pressing the "Pair/Reset"
button
for more than 5 seconds. When the "Pairing Status" indicator
information is deleted.
2.
Insert the transmitters / receivers into the charging compartments so that the charging contacts of the
transmitters / receivers have contact with those in the charging compartments.
3.
Charging will start automatically.
4.
The state of charge of the batteries is indicated by the LED of the appropriate transmitter / receiver:
Indicator light
Off
Flashing green slowly
Green
Flashing yellow slowly
Yellow for 10 seconds
Flashes red slowly for 10 seconds
Flashing green/yellow rapidly
Flashing red rapidly
Red
Unite CDD | CDS Cockpit Charger | Unite DS Basic Charger
or "Auto Pair"
button.
Charging status
Device is switched off
Charging 0 - 100%
Battery is charged
Pairing information is being copied from the transmitter
Device information is copied successfully to charger/devices
• Too many transmitters in the charger when pairing is initiated
• Other pairing error
Device is being localised
Charging error
Firmware update is performed
goes off, the pairing
Werbung
Inhaltsverzeichnis
