16
charger itself for future pairing, press and hold the "Pair/Reset" button
2 seconds. When the "Pairing Status" indicator
Mobile devices that are now being paired indicate this via a status indicator that illuminates yellow.
After successful pairing the "Pairing Status" indicator
that the pairing information is now also stored in the charger.
5.
If you want to pair other receivers, remove the transmitter (Master) and all receivers from the charger
and press the "Auto Pair" button
receivers that are not yet paired into the charger. The pairing information is immediately stored in these
receivers. The "Pairing Status" indicator
the devices that have received the pairing information, the status indicator lights yellow for about 10
seconds. As soon as the "Pairing Status" indicator
complete and you can remove the receivers from the charging compartments.
In order to end the "Auto Pair" function, press the "Auto Pair" button once. The "Pairing Status" indicator
will illuminate green to indicate that the pairing information is stored in the charger.
The "Auto Pair" function is not possible, when no pairing information is stored in the charger. In this case
the "Pairing Status" indicator
6.
Switch on the transmitter and a receiver to check whether the pairing was successful. When the
devices are successfully paired, the status indicator of both devices will illuminate green and the
receiver should display the channel name of the transmitter.
7.
In order to delete the stored pairing information, press the "Pair/Reset" button
Status" indicator
first flashes yellow and the goes out.
Unite CDD | CDS Cockpit Charger | Unite DS Basic Charger
flashes yellow, release the button to perform a pairing.
will permanently illuminate green to display
once. The "Pairing Status" indicator
flashes yellow and displays the active pairing process. On
is permanently lit yellow, the pairing process is
flashes red five times.
on the charger for more than
will illuminate yellow. Insert the
until the "Pairing