Returning The Device; Cleaning; Disposal; Accessories And Spare Parts - Stahl HART Serie Betriebsanleitung

11.4 Returning the Device

• Only return or package the devices after consulting R. STAHL!
Contact the responsible representative from R. STAHL.
R. STAHL's customer service is available to handle returns if repair or service is required.
• Contact customer service personally.
or
• Go to the www.r-stahl.com website.
• Under "Support" > "RMA form", select "Request RMA slip".
• Fill out the form and send it.
Confirmation will be sent. R. STAHL's customer service will contact you.
You will receive an RMA slip after speaking with customer service.
• Send the device along with the RMA slip in the packaging to
R. STAHL Schaltgeräte GmbH (refer to chapter 1.1 for the address).
12

Cleaning

• To avoid electrostatic charging, the devices located in potentially explosive areas may
only be cleaned using a damp cloth.
• When cleaning with a damp cloth, use water or mild, non-abrasive,
non-scratching cleaning agents.
• Do not use aggressive detergents or solvents.
13

Disposal

• Observe national and local regulations and statutory regulation regarding disposal.
• Separate materials when sending it for recycling.
• Ensure environmentally friendly disposal of all components according to the statutory
regulations.
14

Accessories and Spare Parts

Malfunction or damage to the device due to the use of non-original components.
Non-compliance can result in material damage.
• Use only original accessories and spare parts from
R. STAHL Schaltgeräte GmbH.
For accessories and spare parts, see data sheet on our homepage
www.r-stahl.com.
218078 / 946860310010
2018-10-19·BA00·III·en·02
NOTICE
HART Analog Universal Module
for Zone 1 / Div. 1
Series 9468/32
Cleaning
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
23