Engineering; Terminal Assignment Of The Pluggable Terminal X1 - Stahl HART Serie Betriebsanleitung

6

Engineering

An ambient temperature that is too high may cause failure of the devices installed
in the cabinet.
Non-compliance can result in material damage.
• Install and adjust the cabinet in such a way that it is always operated within
the permissible temperature range.
The following conditions must be observed during project engineering:
• To ensure adherence with the intended use, only install the device on the
IS1 BusRail 9494.
• Operation of the device is only permissible in three approved mounting positions:
See the "Mounting/dismounting on BusRail" section.
• Modules with intrinsically safe and non-intrinsically safe field circuits may be operated
simultaneously on one BusRail. In this case, a distance of 50 mm must be maintained
between the terminals with intrinsically safe and those with non-intrinsically safe field
circuits. (e.g. partition 220101 or empty space).
6.1

Terminal Assignment of the pluggable Terminal X1

For the module, a plug-in terminal X1 (screw terminal 162702 or spring clamp terminal
162695) for connecting field devices is available as an accessory (not included in the
scope of delivery of the module). The pluggable terminal X1 has 16 terminals for
connecting the field cables.
X1
1 2 3 4 5 6 7
Terminal X1
Channel 0
2-wire 1(+),
input/ 2(-)
output
with
HART
3-wire Power
input supply
with 1(+),
HART Signal
2(+),
common
4(-)
4-wire 2(+),
input 4(-)
218078 / 946860310010
2018-10-19·BA00·III·en·02
8 9 10 11 12 13 14 15 16
1 2
3(+), 5(+),
4(-) 6(-)
– Power
supply
5(+),
Signal
6(+),
common
8(-)
– 6(+),
8(-)
NOTICE
3 4
7(+), 9(+),
8(-) 10(-)
– Power
supply
9(+),
Signal
10(+),
common
12(-)
– 10(+),
12(-)
HART Analog Universal Module
for Zone 1 / Div. 1
Series 9468/32
Engineering
5 6 7
11(+), 13(+), 15(+),
12(-) 14(-) 16(-)
– Power –
supply
13(+),
Signal
14(+),
common
16(-)
– 14(+), –
16(-)
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
15324E00
EN
EN
15