Installation; Commissioning - Stahl HART Serie Betriebsanleitung

8.3

Installation

Operation under difficult conditions, such as, in particular, on ships,
requires additional measures to be taken for correct installation,
depending on the place of use. Further information and instructions on
this can be obtained from your regional sales contact on request.
The cover flap features an insert disc which can be used to enter the assignment of the
field devices to the channels. IS Wizard can be used, for example, to label the insert disc.
• Connect the field devices to the pluggable terminal X1 according to terminal
assignment (see the "Project engineering" section or insert disc on the inside of
the cover). (Stripping length of at least 7 mm).
• Place the field wiring shields (if available) as close to the entry point of the field
enclosure on the earthing rail as possible.
• Plug the pluggable terminal X1 into the module and secure it against loosening
using screws (tightening torque 0.5 to 0.6 Nm).
The module and the plug-in terminal X1 can be safely connected or
disconnected during operation in the hazardous area (hot swap).
9

Commissioning

Explosion hazard due to incorrect installation!
Non-compliance results in severe or fatal injuries.
• Check the device for proper installation before commissioning.
• Comply with national regulations.
Before commissioning, ensure the following:
• Installation of the device according to regulations.
• Correct connection of the cables.
• No damage at the device and connection cables.
• Tight seat of the screws at the terminals.
Correct tightening torque: 0.5 to 0.6 Nm.
218078 / 946860310010
2018-10-19·BA00·III·en·02
DANGER
HART Analog Universal Module
for Zone 1 / Div. 1
Series 9468/32
Commissioning
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
19