Dimensions / Fastening Dimensions; Mounting / Dismounting, Operating Position - Stahl HART Serie Betriebsanleitung

8.1

Dimensions / Fastening Dimensions

Dimensional drawings (all dimensions in mm [inches]) – Subject to modification
128 mm / 5.04 "
8.2

Mounting / Dismounting, Operating Position

8.2.1 Mounting / Dismounting on BusRail
Malfunction or device damage caused by improper mounting.
Non-compliance may lead to material damage!
• Only install and operate the device in a vertical or horizontal position!
(Horizontal orientation: Reading direction from below)
Mounting on BusRail
218078 / 946860310010
2018-10-19·BA00·III·en·02
BusRail
BusRail
NOTICE
• Position the module vertically at the
intended slot of the BusRail and
press lightly to snap it into place.
• The module may no longer be
loosened without actuating the
notch lever.
• Plug the pluggable terminal X1 into
05683E00
the module and secure it against
loosening using safety screws
(tightening torque 0.5 to 0.6 Nm).
• If necessary, mount a partition to
ensure a distance of at least 50 mm
between the intrinsically safe and
non-intrinsically safe electric circuits
or release the adjacent slot on the
BusRail.
HART Analog Universal Module
for Zone 1 / Div. 1
Series 9468/32
Mounting and Installation
01927E00
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
17