Safety Instructions - Honeywell 041450.17 Montage- Und Bedienungsanleitung

28
The following general symbols will be used in the documentation:
Warning sign
Designates risks for man and/or machine. Non-compliance will create risks to man and/or machine.
The level of risk is indicated by the word of warning:
Caution!
Risk of material and environmental damage.
Warning!
Potential risk which may result in light to medium body injury or in substantial material damage.
Danger!
Potential danger which may result in serious body injury or even in death.
Important information on a topic or a procedure and other important information.
Important information on installation and/or assembly.
Information on installation/programming according to VdS guidelines

Safety instructions

* Please read through these instructions carefully and thoroughly, before installing and operating the device.
These instructions contain important information about installing, programming and operating.
* The device has been built to correspond to the latest level of technology. Please use it only:
- in accordance with regulations and
- in technically perfect and orderly installed condition
- according to the technical information.
* The manufacturer is not liable for damage caused by improper use.
* The accompanying documents and specific system documentation are to be deposited and kept in
a safe place.
* Installation, programming as well as maintenance and repair work may only be carried out by authorised skilled
personnel.
* Soldering work may only be carried out with a thermostatic soldering iron disconnected from the mains.
* Please observe VDE safety regulations as well as the regulations of the local Electricity Board.
* Water and fluids - Keep the device away from water and other fluids.
Danger: The device should never be used in areas where there is a danger of explosion or where
metal- or plastic-corrosive vapours are emitted.
Soldering- and connecting work within the entire system is only to be carried out when the system is
switched off. The insertion and removal of module cards and other electronic components should also
only be carried out when the system is inactive and switched off.
Mounting and Operating Instructions Doorguard for MB panels BUS-2