Drip Coffee Dosing; Adjustment Of Service Boilers; Adjustment Of Service Boiler Temperature/Pressure; Power Function Activation - Bezzera VICTORIA Bedienungsanleitung

5.10 DRIP coffee dosing

The machine is also designed for dosing DRIP
coffee where it is possible to dispense using a
uniform pressure profile set at 3 bar.
Remove the filter-holder from the dosing group,
remove the base grille if necessary and place
under the dosing group a container with a filter
suitable for DRIP coffee filled with ground coffee.

5.11 Adjustment of service boilers

You can access to the service boiler menu from
the main menu by scrolling the image to the left
or by pressing the left arrow
5.11.1 Adjustment of service boiler
temperature/pressure
The two service boilers are separate, one is for di-
spensing steam only and the other for dispensing
hot water and steam. The service boiler tempe-
rature/pressure can be adjusted by selecting the
boiler for which you want to change the setting
and pressing the + and - keys.
The temperatures can be set between 110°C
(230°F) and 133°C (271°F).

5.11.2 POWER function activation

The two service boilers can be connected toge-
ther so that a virtually endless supply of steam is
available.
To enable this function, press the POWER key.
If the POWER function is activated, both the ser-
vice boilers will be set to the temperature for the
left-hand boiler.
N.B. To activate this function, the two boilers must
be turned on using the relevant on/off switches
(Fig. 01; pos. 10).

5.11.3 Rinsing the service boilers

By entering the wash submenu, which is different
for each of the boilers, you can enable the rinse
function and set a specific time for this to occur.
A fixed quantity of water (about 500 ml) will be
taken from the boiler every day at a set time and
renewed with fresh water from the mains water
supply. This function allows for a continuous
changeover of water in the boiler without com-
promising the machine's performance.
Caution: the water taken from the boi-
ler has a temperature of about 130°C
(266°F), so make sure that the draina-
ge system can withstand this tempera-
ture before enabling this function.

5.11.4 Draining the service boilers

By entering the wash submenu, which is different
for each of the boilers, you can enable the drai-
ning function using the "DRAIN BOILER" key.
When this function is selected, the machine auto-
matically drains all the water from the service boi-
lers. When they have been drained, the level will
be renewed with clean water and then, heated to
the set temperature.
Caution: the water taken from the boi-
ler has a temperature of about 130°C
(266°F), so make sure that the draina-
ge system can withstand this tempera-
ture before enabling this function.
45
BEZZERA VICTORIA
MOD.