HBM WE2111 Kurzanleitung Seite 7

WE2111
A3983-1.0 en/de/fr
against unintentional actuation is provided (e.g.
access checks, password protection, etc.).
S Additional safety precautions must be taken in terms
of both hardware and software for devices working in
networks, so that a line break or other interruptions to
signal transmission do not cause undefined states or
loss of data in the automation device.
S After making settings and carrying out activities that
are password-protected, ensure that any controls that
may be connected remain in a safe condition until the
switching performance of the device has been tested.
Additional safety precautions
Additional safety precautions that meet the requirements
of the applicable national and local accident prevention
regulations must be taken in plants where malfunctions
could cause major damage, loss of data or even personal
injury.
The scope of supply and performance of the device
covers only a small area of measurement technology.
Before starting up the device in a system, a project
planning and risk analysis must first be implemented,
taking into account all the safety aspects of
measurement and automation technology so that residual
dangers are minimized. This particularly concerns
personal and machine protection. In the event of a fault,
appropriate precautions must establish safe operating
conditions.
General dangers of failing to follow the safety
instructions
The device is state of the art and as such is failsafe. The
device may give rise to residual dangers if it is
inappropriately installed and operated.
7