14- Reset - Bpt TH 345 Gebrauchsanweisung

TH345.01 ITF 24078822 04_06
grammed interval, press the
button or the button.
Programming in days
13.7 - Press the
figure 68.
The display shows the wording
d01 instead of the actual time.
1 2 3 4 5 6 7
T3
T2
T1
0 4 8 12
1 2 3 4 5 6 7
T3
T2
T1
0 4 8 12
Downloaded from www.Manualslib.com
13.8 - Press the button
until you reach the number of days
required, which can range from 1
to 99, figure 69.
button twice,
The days are counted including the
day during which the programming
option is used (so the remainder of
the day when the setting is made
counts as a whole day).
Note. To return to AUTOMATIC
ON
mode before the expiry of the pro-
grammed interval, press the
button or the
16 20
In the COOLING program:
13.9 - Press the
Fig. 68
The bar under the
ON
T3
T2
T1
16 20 0
Fig. 69
manuals search engine
11-07-2007
button.
button once.
symbol is
1 2 3 4 5 6 7
ON
4 8 12 16 20
8:21 Pagina 27
enabled to confirm the fact that the
or
THERMOPROGRAM is not control-
ling the plant and the program
graph disappears, figure 70.
For 5 s the room temperature rea-
ding disappears and the display
reads .
For programing in hours or days,
proceed as explained for the HEA-
TING program.
14 - RESET
When you need to reset the ther-
mostat to operation after it has
been switched off due to faulty
operation or for other technical
reasons, proceed as follows:
14.1 - Remove the thermostat
from its housing.
14.2 - Press buttons R, figure 71.
14.3 - Replace the thermostat in
its housing.
This operation cancels any perso-
Fig. 70
nalized programs, which are resto-
27
GB