Using The Cooking Zones; Bridge Function; Automatic Heat Up; Power Function - Electrolux EHI8742FOK Benutzerinformation

4.4 Using the cooking zones

Put the cookware on the cross / square
which is on the surface that you cook.
Cover the cross / square fully. Induction
cooking zones adapt to the dimension of
the bottom of the cookware automatically.
You can cook with the large cookware on
two cooking zones at the same time.

4.5 Bridge function

This function connects two left side
cooking zones and they operate as one.
First set the heat setting for one of the left
side cooking zones.
To activate the function: touch
set or change the heat setting touch one
of the control sensors.
To deactivate the function: touch
The cooking zones operate independently.
When you use only one cooking zone of
the pair we recommend that you use the
rear cooking zone. Also when you use
large cookware we recommend that you
put it near to the rear cooking zone.

4.6 Automatic Heat Up

If you activate this function you can get a
necessary heat setting in a shorter time.
The function sets the highest heat setting
for some time and then decreases to the
correct heat setting.
To activate the function for a cooking
zone: touch
Immediately touch the correct heat
setting. After 5 seconds
To deactivate the function: change the
heat setting.

4.7 Power function

This function makes more power available
to the induction cooking zones. The
function can be activated for the induction
cooking zone only for a limited period of
time. After this time the induction cooking
Downloaded from www.Manualslib.com
To activate the function the
cooking zone must be cold.
( comes on).
comes on.
manuals search engine
zone automatically sets back to the
highest heat setting.
Refer to "Technical
information" chapter.
To activate the function for a cooking
zone: touch
To deactivate the function: change the
heat setting.
4.8 Timer
Count Down Timer
You can use this function to set how long
the cooking zone should operate for a
single cooking session.
. To
First set the cooking zone then set the
function. You can set the heat setting
before or after you set the function.
.
To set the cooking zone: touch
again and again until the indicator of a
necessary cooking zone comes on.
To activate the function: touch
the timer to set the time (00 - 99 minutes).
When the indicator of the cooking zone
starts to flash slowly the time counts
down.
To see the remaining time: set the
cooking zone with
cooking zone starts to flash quickly. The
display shows the remaining time.
To change the time: set the cooking
zone with . Touch
To deactivate the function: set the
cooking zone with
remaining time counts back to 00. The
indicator of the cooking zone goes out.
When the time comes to an
end, the sound operates and
00 flashes. The cooking zone
deactivates.
To stop the sound: touch
CountUp Timer (The count up timer)
You can use this function to monitor how
long the cooking zone operates.
ENGLISH
. comes on.
of
. The indicator of the
or .
and touch . The
.
9