Power-Saving Mode - Panasonic CF-VDM741U Bedienungsanleitung

Using the Drive

Power-saving Mode

If the drive is not accessed for 30 seconds, the drive motor will automatically be shut down
to reduce the power consumption. When the drive is accessed again, the drive motor is
turned on. In this case, reading of the disc data will take approximately 30 seconds.
Information
To play DVD-Video or MPEG2 files;
<Only for CF-74 series>
Use "WinDVD" preinstalled in the computer.
<Only for CF-51 series>
Install "WinDVD" using "DVD Drive Utility Disc" (included) (
E
Region Code Setting
DVD-Video are allocated to region codes according to where they are sold. To play a DVD-
Video, the player's software and the drive must have the corresponding region code.
e.g.,
For U.S.A. and Canada: "1"
For Europe: "2"
The region code of the drive is not set at purchase. The operation depends on the DVD-
Video that is first played.
• DVD-Video with a specific region code:
The drive will automatically be set at the same region code as the DVD-Video.
• DVD-Video with multiple region codes:
[Confirm Region] appears. Select the region code and click [OK]. Play now begins.
CAUTION
You can change the region code setting up to five times including the initial setting.
Be extremely careful because you cannot change the region code anymore after the
fifth change, even if you reinstalled the operating system.
Any problem resulting from illegal changing or altering of the region code is the
user's responsibility.
NOTE
[Confirm Region] appears when the DVD-Video has only one region code and the
drive is set for another region code.
([Confirm Region] may not appear with some DVD-Video discs. To check the cur-
rent region code and the number of remaining times of changing the code, right-click
on the WinDVD screen and click [Setup] - [Region].)
10
page 15).