Power-Saving Mode - Panasonic CF-VDD272 Bedienungsanleitung

5 Press (Alt ) (Alt) +(E), then (S) to save the file. Then press (Alt) +(E), then (X) to
exit the Edit program.
6 Follow the same steps to edit the "AUTOEXEC.BAT" file.
edit autoexec.bat
/ Move the cursor to the line containing "MSCDEX.EXE" and delete the characters "rem"
at the beginning of the line. (Deleting "rem" causes the item to become valıd.)
LOADHIGH C:\WINDOWS\COMMAND\MSCDEX.EXE /D:MSCD000 /L:L
(If this line is missing, add it.)
8 Press (Alt ) + ©), then cS) to save the file. Then press (Alt) + (F), then OO to D
exit the Edit program.
9 Restart the computer.
Power-saving mode
If the DVD-ROM Drive Pack has not been accessed within 120 seconds, the drive motor
will automatically shut down to reduce the power consumption. When the DVD-ROM
Drive Pack is accessed once again, the power of the drive motor is turned on. However,
approximately 30 seconds are required until data is actually read from the disc.
@ [3'" Floppy (A:)] displayed in [My Computer] can be selected, only when you use a
floppy disk drive as an external device (G page 6).
@References to "CD-ROM" in the Setup Utility will not change depending on the
computer when the DVD-ROM Drive Pack is installed.
@ If the vibration of the DVD-ROM drive is excessive, set the CD-ROM/DVD-ROM
Drive Speed to [12x](or displayed [Low]) in Setup Utility. (The display of the item
may remain unchanged depending on the computer when the DVD-ROM Drive Pack
is installed. )