Power-Saving Mode - Panasonic CF-VDM302AU Bedienungsanleitung

Setting a Disc
1
Turn on the computer.
2
Slide the latch (A) and open the cover.
3
Press the eject button (B) and slowly
pull out the tray.
4
Insert/Remove the disc.
To insert
Set the disc with the label side up and press the
center of the disc until it clicks in place.
To remove
Press on the center spindle (C) and carefully lift up
the edge of the disc.
5
Close the tray.
Do not press the eject button.
NOTE
To remove a disc when the computer is powered off, insert a pointed object (e.g.,
the bent-out tip of a paper clip) into the emergency hole (D). Pushing it to the end
allows the tray to come out.
<Only for CF-30 C/D/E/F/G/J series>
If the vibration of the drive is excessive, check the disc. If the disc is normal and
is inserted correctly, set [DVD Drive Speed] to [Low] in the [Main] menu of the
Setup Utility (
For AutoPlay CD:
• If an AutoPlay CD does not start after the computer resumes from sleep
nate, remove the disc from the drive and then reinsert it after waiting 15 seconds.
• An AutoPlay CD may start during file access depending on the status of the disc.
When playing back video from a disc, playback may not be smooth in some conditions.
*1
Windows XP

Power-saving Mode

If the drive is not accessed for 30 seconds, the drive motor will automatically be shut
down to reduce the power consumption. When the drive is accessed again, the drive motor
is turned on. In this case, reading of the disc data will take approximately 30 seconds.
Reference Manual "Setup Utility").
Standby
E
*1
or hiber-
9