MEDICA THERA-vital Gebrauchsanweisung Seite 38

–
Treading resistance (Neuro): In the training
mode Neuro (see page 41) you can adjust the
treading resistance.
The actual treading resistance is shown in
16 steps. The 16th step accords to a maxi-
mum power torque of 12 Nm.
You can increase the treading resistance by
pressing the button +. To increase the tread-
ing resistance step by step press the button
shortly.
You can decrease the treading resistance un-
til zero by pressing the button –.
The adjustment will change constantly to
maximum/minimum by pressing the buttons +
and – for longer time.
Power demand settings in Watt (Ortho): In
the training mode Ortho (see page 41) you
can adjust the training "Power demand ". The
wished capacity gets set by the buttons +
and –. THERA-vital regulates the treading re-
sistance in accordance to the number of rev-
olutions.
Downloaded from www.Manualslib.com
Treading resistance/
+
Capacity settings
You can regulate the power
or capacity you want to train
10
with. Following adjustments
1/min
are possible:
change constantly to maximum/stop by press-
ing the buttons + and – for longer time.
If you increase the number of revolutions be-
fore the training THERA-vital will start with the
number of revolutions you have adjusted. The
automatic program (see page 36 and 39) is
not activated.
Power demand (Ortho): In training-mode
Ortho (see page 41) you can adjust the train-
ing-art "Power demand" and you can choose
the desired number of revolutions (Isokinetic
Mode). THERA-vital regulates the treading re-
sistance automatically in accordance to the
expended muscle-power.
are save from to much stress by THERA-vi-
tal's spasm-control.
Pressing the button puts the spasm-control on
or off. The active spasm-control is shown in
dark.
THERA-vital stops immediately if the device
recognizes a spasm. The display shows
"SPASM". After 5 seconds the device starts
manuals search engine
Number of revolutions
+
Press the button + to in-
crease the number of revolu-
tions. To increase the
–
34
number of revolutions step
by step push the button
shortly. The adjustment will
Spasm
Patients that suffer from
spasm or that have very
sensible bones and joints
35
again with a leading number of revolutions
reduced by 5 revolutions per minute (see also
"Spasm programming" page 39).
Please read also the remarks on
page 30 "If Spasm occurs".
Direction of rotation
The actual direction of rota-
tion is shown by the dark
symbol. If you press the but-
ton the direction of rotation changes.
The direction always changes with a soft stop
and a soft a start. The rest of the parameters
(number of rotations, motor power, arm-/feet-
trainer, spasm control) stay as they were set.
Leg trainer/upper
torso trainer
You can either activate the
leg trainer or the upper
torso/arm trainer. The active trainer will be
symbolised in dark.
Press the button before starting the training,
press it in a pause to change between the
feet- and the upper torso trainer.
The button is not active during the training or
if there is no upper torso trainer assembled.