Charging The Rechargeable Battery; Battery Status; Operation; Stand-Alone Mode - EuroLite AKKU IP PAR 7 QCL Bedienungsanleitung

Charging the rechargeable battery

Prior to operating the device off mains for the first time, the rechargeable battery must be fully charged. You
can charge the product using the power cable.
1
Switch on the device with the power button. The operating time of the battery depends on the operating
mode and the ambient temperature (max. 9 hours). After the operation, switch the device off.
2
For charging the battery, connect the device to a power outlet via the power cable provided. Charging
time is 4 hours. The device may be operated during the charging procedure.
3
The device features a protective circuit for charging which prevents overload of the rechargeable
battery. However, disconnect the device from the mains after charging. Otherwise there will be a low
current consumption even if the device is switched off.
4
The device will heat up during charging; this is normal.
5
To prevent damage to the battery by deep discharge, recharge a completely discharged battery as soon
as possible. Do not store the unit with the battery completely discharged and regularly recharge the
battery in case of long storage.
Maximum battery run time
9 hours

Battery status

The battery charge status is indicated on the display. The battery charge status is indicated by four levels. If
all four levels are lit, the battery is fully charged. If only one level is lit, the last one, the battery will be going
flat soon. In this state, the device can be operated for a few minutes. Then an emergency switch-off
deactivates the device to protect it from total discharge.

OPERATION

After you switch on the device with the power button the device starts running. The display lights up and you
can choose the desired mode via the buttons MENU, ENTER, UP and DOWN.
The device features a memory function. The last program selected will begin anew when the device is
restarted.
The device has two operating modes. It can be operated in stand-alone mode via the control board and the
EUROLITE IR-35 remote control or in DMX-controlled mode via a standard DMX controller and WDMX with
suitable wireless transmitter.

Stand-alone mode

In the stand-alone mode, you can do without a controller. De-activate WDMX and call up the desired setting.
Please refer to the instructions under Control Board.

Master/slave operation

Several devices may be interconnected. Then all slave units can be synchronized and controlled with the
master unit without the need for a DMX controller. The devices must be set to the corresponding operating
modes.
1
Set the master device to the mode Master. Set the slave mode Slave on every slave device. Please
refer to the instructions under Control Board.
2
Connect the DMX output of the master unit to the DMX input of the first slave unit. Then connect the
DMX output of the first slave unit to the DMX input of the second slave unit, etc. until all units have been
connected in a chain. Make sure the master unit is the first in the chain. Do not connect a DMX
controller to the DMX input of the master unit.
3
The interconnected devices will now operate synchronously.
Recharge time
4 hours
27/36 00128030, Version 1.0