Charging Procedure - Motorola PMPN4308 Schnellstartanleitung

Charging Procedure

1. Place the Multi-Unit Charger (MUC) on a flat surface.
2. Firmly insert the power supply into the charger DC Inlet Socket at the back of the
charger.
3. Plug the power supply power cord into a matching power outlet.
4. Upon successful power-up, each pocket LED shows Green for one second and
IMPRES 2 MAINTENANCE CHGR is displayed. If the LEDs do not flash and no message
is displayed, check power cord connections.
5. Insert the battery into an available pocket.
6. When the battery is properly seated in the pocket:
- Charging status of a battery is indicated by the LED Status Indicator of the associated
pocket on the MUC.
- The Display of the MUC shows the charging status of Pocket 1 only.
7. The battery is ready when LED is Steady Green (for non-IMPRES or non-IMPRES 2
Motorola Solutions battery) or Alternating Amber/Green (for IMPRES or IMPRES 2
Motorola Solutions battery).
4
Figure 2: Charging Procedure