Using The Oven - Sharp K-62D19IM0-EU Bedienungsanleitung

USING THE OVEN

CONTROL PANEL FOR
VITROCERAMIC HOB
HEAT SETTING KNOBS FOR
VITROCERAMIC COOKERS
Heat setting knobs for vitroceramic
cookers
The appliance is operated by using
knob control and the heat stored
isconfirmed by residual heat indicator
lamp on the vitroceramic surface
Knob controlled cooker is designed
foroperating at 6 heat levels:
1Keeping warm position
2-3Heating position at low heat
4-5-6Cooking – roasting and
boilingposition
Dual and oval heaters have two
heatingzones. To activate the outer
zone of adual/oval heater, turn the
knob to position once. In this way
both outerzones switches on.
To deactivate the outer zone of a
dual/oval heater, turn the knob to
position once. In this way, both
outerzones
Residual Heat Functions
After all cooking processes there is
someheat stored in the vitroceramic
glass called residual heat. The
control cancalculate roughly how hot
the glass is in the worst case. If the
calculated temperature is higher than
+ 60 ° C,then this will be indicated
in the related residual inducator
heat indicator lamp. The residual
heat display is shown as long as the
calculated heater temperature is > +
60° C.
After reapplying the supply voltage to
the hob control after an interruption
of the supply voltage occurred,
causes that the residual heat display
flashes,if the corresponding heater
had a residual heat of greater + 60 ° C
EN -12-
switches off.