Troubleshooting - Philips GC4900 Serie Bedienungsanleitung

ENGLISH
12
Problem
The iron cannot
remove wrinkles
from the garment.
Water drips from
the soleplate after
the iron has been
unplugged or has
been stored.
The light on the
iron is amber
instead of blue,
and keeps flashing.
The SmartLight
pulsates slowly.
4 Wind the mains cord around the cord winding area and fix
it with the cord clip. Put the mains cord below the CordFix
indication to ensure the mains cord does not touch the hot
soleplate during storage.
5 Store the iron on its heel in a safe and dry place.

Troubleshooting

This chapter summarises the most common problems you
could have with the appliance. If you are unable to solve the
problem with the information below, visit www.philips.com/
support for a list of frequently asked questions or contact the
Consumer Care Centre in your country.
Possible cause
There is no steam during
ironing.
The steam slider is set to
MAX.
You have put the iron in
horizontal position with
water still left in the water
tank.
The Calc-Clean reminder
light has been activated.
This is a regular reminder
for you to descale the
appliance.
The Safety Auto-off mode
is active. The iron has
switched to standby mode
(see chapter 'Safety Auto-
off').
Solution
Put water inside the water tank. Set
the steam slider to MAX.
Set the steam slider to 'no steam'.
Empty the water tank.
Perform the Calc-Clean process
(see chapter 'Cleaning and
maintenance', section 'Calc-Clean
System').
Move the iron to reactivate it.
The iron starts heating up again.
Start ironing again only when the
SmartLight lights up steadily.