Philips Coolskin HQ6730 Bedienungsanleitung Seite 13

to your local Philips dealer or contact the Service
Department of Philips Domestic Appliances and
Personal Care BV.
Troubleshooting
1
Cause: not enough shaving gel/lotion has been
,
applied.
Solution: press the pump button a few times
,
until sufficient NIVEA FOR MEN shaving
gel/lotion has been released to allow the shaving
heads to move smoothly over your face again.
2
Cause 1: the shaving heads are dirty. The shaver
,
has not been cleaned immediately after use
and/or has not been rinsed long enough and/or
the water used to rinse the shaver was not hot
enough
Solution 1: clean the shaver thoroughly before
,
you continue shaving. See chapter 'Cleaning and
maintenance'.
Cause 2: long hairs are obstructing the shaving
,
heads.
2 2
Solution 2:
,
1
1 1
1 1
2
3
Do not clean more than one cutter and guard
at a time, since they are all matching sets. If you
accidentally mix up the cutters and guards, it
The shaving heads do not move smoothly over
the skin.
Reduced shaving performance
Press the release button and open the shaving
unit.
Turn the wheel anticlockwise (1) and remove
the retaining frame (2).
Clean the cutters and guards.
EnglisH
15