Operation And Controls; Fitting The Parts - Princess 212015 Anleitung

Randstad_Classic_Compact_Blender_212014.book Page 4 Tuesday, August 8, 2006 9:51 AM
General
You can use this attractive Compact
Blender to finely chop vegetables and fruit,
and to prepare delicious shakes and
juices.
The blender is equipped with a powerful
motor that can be set to one of two
continuous speeds or a pulse mode. The
sharp stainless-steel knives enable you to
finely chop or purée both small and large
pieces of fruit and vegetables with the
greatest of ease. This useful appliance
also has a closable lid; the filling opening in
the lid can be used to add ingredients
during blending without spillage. The
rubber feet under the blender prevent it
from moving whilst in use. Connect the
appliance to the mains power supply
(220 - 240V).
Operation and
controls
See Figure 1.
The appliance has the following features:
1 Housing
2 On/Off switch
3 Calibrated jug
4 Lid
5 Lid insert
6 Power cord and plug
Before use for the first time
1 Remove the packaging.
2 Clean the appliance. See 'Maintenance
and cleaning'.
4
Compact Blender Article 212014 / 212015

Fitting the parts

1 Fit the jug to the housing. The three
lugs on the housingmust fit precisely
into the slots in the base of the jug.
2 Place the lid on the jug.
3 Fit the lid insert in the lid, and lock it by
turning it through 90 degrees.
4 Dismantle the parts in the reverse
sequence.
Blending products
1 Cut the fruit and/or vegetables into
pieces that fit in the jug. Do not cut into
pieces that are too large, since they will
need to be small enough to fall to the
base of the jug.
2 Open the lid, and put the pieces in the
jug.
3 Fit the lid back onto the jug to prevent
splashing.
4 Switch on the blender in position 1 or 2,
or in the pulse mode (P). The
smoothness of the blend increases with
longer blending times.
5 If necessary, top up the contents by
opening the lid insert; turn the lid insert
through 90 degrees and remove it from
the lid. If the pieces are too large for the
filling opening then switch off the
blender, remove the lid, and add the
product. Put the lid back on the jug
before switching the blender on again.
6 Switch off the blender (position 0) once
you have processed the required
quantity of fruit and/or vegetables.
7 Remove the plug from the wall socket.