Cleaning The Rinsing Pump; Replacing The Rinsing Pump; Storage/Overwintering - Oase ProfiClear Premium TF-XL Gebrauchsanleitung

- EN -
8.8

Cleaning the rinsing pump

T I P
It is often possible to remove soiling from the rinsing device and rinsing pump by
cleaning the rinsing device without the nozzle/nozzles.
• Remove the nozzle/nozzles for cleaning so that the dirt particles are flushed out.
Preparatory work:
• Remove the filter drum. (→ Removing the filter drum)
How to proceed:
 X
1. Undo the fastening device. To do this, unhook both rubber straps.
2. Lift the rinsing pump and remove the filter sock.
– Clean all parts in clean water.
8.9

Replacing the rinsing pump

Preparatory work:
• Remove the filter drum. (→ Removing the filter drum)
How to proceed:
 Y
1. Undo the fastening device. To do this, unhook both rubber straps.
2. Loosen the hose clip and pull off the hose.
3. Take out the rinsing pump and replace.
– Disconnect the connection cable from the cable harness.
4. Fit the rinsing pump in the reverse order.
9.

Storage/overwintering

The unit is protected from frost (e.g. stored in a garage or other enclosure)
The unit can be operated as long as the water temperature does not go below +4 °C.
Set the interval for time-dependent cleaning to 20 minutes to avoid damage to the rinsing
•
device in the event of frost.
Install the control system in such a way that it is protected. The minimum operating
•
temperature of the control system is -10 °C.
The unit is not protected from frost (e.g. outdoor installation)
Take the unit out of operation at water temperatures below +8° C or, at the latest, when freezing
temperatures are to be expected.
• Drain the unit as far as possible, clean thoroughly and check for damage.
Empty all hoses, pipes and connections as far as possible.
•
• Leave the slide valves open.
Cover the container so that no rain water can enter.
•
• Protect pipes and slide valves that are in contact with water from frost.
N O T E
The drum seal requires maintenance after winter or at the beginning of the pond season.
• Remove the old grease, then apply new grease sparingly to the edge of the drum.
80