Functions In Service Mode; Reset The Receiver To The Factory Setting - Selve commeo Adapter Plug Betriebsanleitung

iveo initial operation/Setting

7.2. Functions in service mode

In order to carry out the following settings, the receiver has to be put
into service mode by disconnecting it from the mains supply in a
special way.
Consider the following:
• Transmitter programmation has to be finished before service mode
can be executed.
• The receiver remains in service mode for 4 minutes.
Unplug and plug­ in the receivers
3 s 3 s
The receiver confirms the service mode by a short flash of the LED.

7.3. Reset the receiver to the factory setting

The factory setting means that no transmitter has been programmed.
In order to reset the receiver to the factory setting, the receiver has to
be put into service mode by disconnecting it from the mains supply.
Subsequently press the PROG button of a programmed transmitter
for 9 sec.
Unplug and plug­ in the receivers
3 s 3 s
3 s
3 s
33
Transmitter
➧
9 s
GB
GB