General; Designated Use; Selve Commeo/Iveo Radio - Selve commeo Adapter Plug Betriebsanleitung

General

3. General
The commeo Adapter Plug operates electrical users by the receipt of
SELVE commeo/iveo radio signals.

3.1. Designated use

The Adapter Plug may only be used for the switching of devices with
SCHUKO®­ or Europlugs. The maximum switching capacity is 2300
Watt (10 A).
• Please note that radio sets cannot be operated in areas with in­
creased risk of interference (e.g. hospitals, airports).
• The remote control is only permitted for equipment and systems
with which a malfunction in the hand­held transmitter or receiver
does not present a risk to persons, animals or objects, or this risk
is covered by other safety devices.
• The operator does not enjoy any protection from disturbances by
other remote signalling equipment and terminal equipment.

3.2. SELVE commeo/iveo radio

The commeo Adapter Plug receives radio signals on 868.1 MHz
(commeo radio) and 868.3 MHz (iveo radio). The two radio systems
can not be operated at the same time.
commeo is a bidirectional radio system that saves data in the receiver
as well as the transmitter. This makes a feedback from the receiver to
transmitter possible. iveo is an unidirectional radio system without
feedback which is compatible with the intronic radio system.
The receiver is compatible with both radio systems after it has been
disconnected from the mains supply as long as the teaching process
for a commeo/iveo transmitter has not already been completed. If you
wish to change the radio system retrospectively, the programming for
all transmitters of the other radio system must be re­programed. The
receiver must then be disconnected from the mains supply.
All SELVE commeo/iveo transmitters can be programmed into these
receivers. Up to 16 transmitters can be programmed into one motor.
Please adhere to the transmitter operating instructions.
23
GB
GB