Programming/Deleting Transmitters; Delete Transmitter Table In The Receiver - Selve commeo Adapter Plug Betriebsanleitung

commeo initial operation/Setting
Note for settings under point 6.2.: The receiver must be selected
for this setting with a transmitter in SELECT mode (Status LED
flashes slowly in orange). After completing the setting, the motor/
receiver is still selected (see point 6.).

6.2.1. Programming/deleting transmitters

To program or deprogram a transmitter, select the desired channel
and push the PROG button for 1 second. The status LED lights up
green to indicate that the transmitter has been programmed. A red
light means that the transmitter has been deprogrammed.
1 s

6.2.2. Delete transmitter table in the receiver

To delete the transmitter table in the receiver, push the PROG button
on the transmitter for 6 seconds. All transmitters programmed in the
receiver are deleted.The programmed receiver has been cancelled in
the transmitter.
Note: This causes an error message if there are any
more programmed receivers!
If this receiver will be controlled by a still programmed
transmitter in operating mode, the transmitter will no
longer receive a feedback and confirms this with a red
6 s
LED as error message.
Status LED transmitter = green
 c hannel/transmitter programmed
Status LED transmitter = red
 c hannel/transmitter deleted
29
GB
GB