Reset The Receiver To The Factory Setting; Transmitter Functions - Selve commeo Adapter Plug Betriebsanleitung

GB
commeo initial operation/Setting
Note for settings under point 6.2.: The receiver must be selected
for this setting with a transmitter in SELECT mode (Status LED
flashes slowly in orange). After completing the setting, the motor/
receiver is still selected (see point 6.).

6.2.3. Reset the receiver to the factory setting

To reset a receiver to factory settings, push the PROG button on the
transmitter for 9 seconds. All settings are reset to factory settings.
There are no transmitters saved in the receiver anymore! The pro­
grammed receiver has been cancelled in the transmitter.
Note: This causes an error message if there are any
more programmed receivers!
If this receiver will be controlled by a still programmed
transmitter in operating mode, the transmitter will no
longer receive a feedback and confirms this with a red
9 s
LED as error message.

6.3.Transmitter functions

The transmitter and receiver are in operating mode.
Deleting all receivers in the transmitter
To delete all receivers from a transmitter, push the SELECT and
PROG buttons at the same time for 9 seconds. Then all receivers are
deleted from the transmitter.
9 s
30