Operation With Touch Controls; Igniting And Adjusting - Pelgrim GK564 Anleitung

OPERATION WITH TOUCH CONTROLS

Igniting and adjusting (GKT564/GKT595)
EN 8
A burner indicatior above the touch controls indicates which burner is
being controlled. The power can be set in 7 levels.
Switching on
Touch and hold the On/Off button for 2 seconds to switch on the hob.
The hob switches on and the display for each cooking zone will show
'0' to indicate that none of the burners is ignited.
Lighting burners with spark ignition
• Touch the + button of the burner you want to ignite.
'0' is blinking for 3 seconds.
• Touch the + button again within 3 seconds to set level 7 or touch
the - button within 3 seconds to set level 5.
The burner ignites and the display shows the level. The display
above the timer button shows the burners that are ignited and that
are linked to a timer.
The control system will make three attempts at intervals of 10 seconds
to ignite the burner. Should the burner fail to light, it locks and the
corresponding display shows 'b'. To use the burner again, you must
release the burner.
Setting a burner level
If a burner has ignited, you can set the level with the corresponding
+ button or - button. You can touch the button several times or you can
touch and hold the button until the correct level appears in the display.
Releasing a burner
• Be sure that the hob is switched on.
• Touch the most left-handed - button and the child lock button
simultaneously for at least two seconds.
You will hear a short beep; you can release the buttons. The display
of the burner that has to be released shows '0' to indicate that you
can ignite the burner again.
When the burner does not ignite, check whether:
• the burner cap is placed on top of the burner correctly;
• the burner/spark plug is clean and dry.