Totally Wicked Revolution VT60 Handbuch Seite 9

Using your Revolution VT60
Tips for using VT Atomizer Head
1. When using a new VT atomizer head, please prime the cotton of the atomizer head with a
few drops of e-liquid to ensure it is moist before the first use to ensure best performance.
2. If the atomizer has been kept without use for some time after filling with e-liquid, there may
be crackles when first firing, which is normal.
3. If redundant e-liquid piles up around the coil, it may be that the atomizer coil cannot reach
protection temperature when in use. Please press the fire button and blow out redundant
e-liquid through airflow holes if this issue occurs
New coil fitment: If the atomizer head is removed from the Revolution VT60 and then
refitted, it may require resetting of the atomizer "base resistance" – this being the resistance
of the atomizer coil when it is cold. After changing the atomizer head, especially when
changing to a different type, press the power button while the tank is removed to provoke a
reset. When the message "New Coil Right, Same Coil Left" appears on the display, push the
output adjuster to the right to confirm that a new atomizer head has been fitted.
16
Downloaded from www.Manualslib.com manuals search engine
Should you see this message for any other reason – especially
when refitting a coil that is still warm from recent use – push
the output adjuster to the left so that the "base resistance" is
not reset.
Always remember to change the operational mode to suit the
coil material that you have fitted to ensure that temperature
control is accurate.
Note:
(1). When the device detects the coil resistance is 5%+0.01Ω
greater than previously detected, it alarms "New Coil Right,
Same Coil Left" in case a new atomizer has been fitted.
(2). When the device detects the coil resistance is 5%+0.01Ω
less than previously detected, the device uses the current
resistance as the "base resistance".
OR
17