Seite 2
CONGRATULATIONS ON PURCHASING YOUR TOTALLY WICKED D16 ELECTRONIC CIGARETTE...
Seite 3
Mouthpiece Atomizer Power Button D16 Tank Atomizer Base Battery Body...
Seite 4
Using your D16 Kit maximum fill level. Filling the D16 Tank with e-liquid: Grip the base of the D16 tank and Note: Be sure to “prime” the remove the tank from the battery by unscrewing. Once removed turn atomizer head before first use by...
Seite 6
Using your D16 Kit Powering On and Off: Installing/Replacing an Atomizer The D16 kit uses a 5 click on/off Head: function. To switch the D16 on, To install a new atomizer head, press the power button five times remove the tank base as described in quick succession.
Seite 8
Using your D16 Kit Charging the Battery: Vaping: The D16 battery is recharged by Press and hold the power button inserting the micro USB cable into as you inhale vapour from the the micro USB port situated to the mouthpiece. Release the power left of the vape button.
Seite 9
Using your D16 Kit Battery Life Indication: The remaining battery charge is indicated by the illumination of the LED shortly after the devices power button has been released. The battery’s remaining level of charge and corresponding light conditions are detailed in the table below.
Seite 10
5.0ohms, the vape buttons below 0.2ohms, the LED will flash LED will slowly flash to indicate the 3 times and the D16 kit will not atomizer heads resistance is too produce power or vapour. If the high. If the incompatible resistance...
Seite 11
Low Voltage Protection: To protect the atomizer head, the When the internal battery cell’s D16 has a 10 second cut off safety remaining voltage drops below feature. If the vape button is held 3.3V, the LED will flash 40 times...
Warranty The D16 kit components have a 28-day parts warranty, with the exception of atomizer heads, which are a consumable item and covered by ‘dead on arrival’ warranty only. The USB cable supplied has a 12-month warranty. If...
Seite 15
• Do not use the device when temperatures are outside the range -10 - 60°C. • Do not charge the battery when temperatures are outside the range 0 - 45°C. • Do not attempt to repair a faulty D16 as these are sealed units with no serviceable parts. Attempted repairs will void the warranty.
Seite 16
GLÜCKWUNSCH ZUM KAUF IHRES TOTALLY WICKED D16 E-ZIGARETTEN KITS.
Seite 17
Mundstück Verdampferkopf Powertaster D16 Tank Verdampferbasis Akku...
Seite 18
Bedienung Ihres D16 Kits überfüllen. Setzen Sie anschließend D16 Tank befüllen: alle Komponenten in umgekehrter Schrauben Sie zunächst die Reihenfolge wieder zusammen. gesamte Tankeinheit vom Akku ab. Drehen Sie den Tank mit Hinweis: Träufeln Sie vor der dem Mundstück nach unten und...
Seite 20
Bedienung Ihres D16 Kits Power Ein/Aus: Verdampferkopf-Installation: Das D16 Kit verfügt über eine 5-Klick Entfernen sind die Verdampferbasis Ein/Aus-Funktion. Drücken Sie zum wie unter “D16 Tank befüllen” Einschalten den Powertaster 5-mal beschrieben. Der Verdampferkopf zügig in Folge. Die Powertaster kann durch einfaches ziehen LED blinkt danach 5-Mal auf von der Basis entfernt werden.
Seite 22
Bedienung Ihres D16 Kits Akku aufladen: Dampfen: Der D16 Akku wird mit dem USB- Powertaster drücken und inhalieren. Kabel am Mikro-USB-Port (links Wenn der Taster gedrückt wird, neben dem Powertaster) aufgeladen. leuchtet eine LED auf. Nutzen Sie bitte als Stromquelle einen geeigneten USB-Port oder USB-Netzstecker.
Seite 23
Bedienung Ihres D16 Kits Akku-Ladestandanzeige: Der Ladestand des Akkus ist nach jeder Betätigung des Powertasters über unterschiedliches Aufleuchten der LED ersichtlich – siehe nachfolgende Tabelle. Akkuladestand LED Indikatoren 60%-100% Dauerleuchten 30%-59% Pulsierendes Aufleuchten 10%-29% Schnelleres Aufleuchten 0-9% Schnelles Aufleuchten...
Seite 24
Bedienung Ihres D16 Kits Kurzschluss-Schutzfunktion: Widerstandsanzeige: Wenn das Gerät einen Wenn das Gerät einen Verdampferkopf-Kurzschluss erkannt Verdampferkopf-Widerstand höher hat oder der Widerstand ist niedriger als 5 Ohm erkannt hat, blinkt die als 0.2 Ohm, blinkt die LED 3-mal LED langsam auf. Vergewissern...
Seite 25
Bedienung Ihres D16 Kits 10 Sek. Sicherheitsabschaltung: Niederspannungsschutz: Hält man den Powertaster langer Fällt die Akku-Spannung auf unter als 10 Sek. gedrückt, wird die 3,3 Volt, blinkt die LED 40-mal auf Stromzufuhr an den Verdampfer und das Gerät schaltet sich ab –...
Kit Inhalt: 1 x D16 Tank 1 x D16 Akku 1 x HC 1.6 Ohm Verdampferkopf (bereits eingesetzt) 1 x HC 1.6 Ohm Verdampferkopf (Ersatz) 1 x USB Kabel 1 x Bedienungsanleitung...
Seite 27
Spezifikationen D16 Akku Spezifikationen D16 Tank Abmessungen: 93mm x 16,5mm Abmessungen: 58,6mm x 16,5mm Akkuzellen: Integriert Tankkapazität: 2ml Akzeptierte Verdampferkopf- Verdampferkopf-Typ: HC Widerstände: 0.2 Ohm – 5 Ohm Maximaler Durchmesser für Verdampferanschluss: 510er Einfüllstutzen: 3,7mm Gewinde...
Produkt. Sollten Sie glauben eine Nebenwirkung zu verspüren, kontaktieren Sie bitte den Hersteller. Garantie Die D16 Kit Komponenten haben eine 28-tägige Garantie. Verdampferköpfe sind als Verschleißteil von der Garantie ausgeschlossen und durch eine DOA- Regulierung abgedeckt. Das mitgelieferte USB-Kabel hat eine 12-monatige Garantie.
Aufbewahrungshinweise und Sicherheitsinformationen • Das D16 Kit und das Zubehör außerhalb der Reichweite von Kindern aufbewahren. • Schalten Sie das D16 Kit aus, wenn nicht in Gebrauch. • Vermeiden Sie versehentliches Drücken des Powertasters, wenn das D16 Kit nicht in Gebrauch ist.
Seite 30
Tel 01254 692244 Manufactured in China www.totallywicked.co.uk under the authority of Pillbox38 UK Ltd, Tel 1(888) 761-9425 Stancliffe Street, www.totallywicked.com Blackburn, Lancashire, Tel 0941-78447082 BB2 2QR. www.totallywicked.de...