Names And Functions Of Controls; Remote Controller - Toshiba RBC-IR2-PE Benutzerhandbuch

K7020 Modular Multi Infra Red
All of the display items are shown in the diagram below for the purpose of
explanation. Only selected items are displayed in actual operation.
2
1. Battery Compartment
Use the two batteries supplied or two
AAA (LR03) 1.5V equivalents. To install
the batteries, insert as shown on legend
in battery compartment.
2. HEAT PUMP/COOL ONLY Switch
If the remote controller is to be used
with a cooling only system, move the
selector switch to 'COOL ONLY'. This
will remove 'AUTO' and 'HEAT' options
from the remote.
3. CUSTOM/MULTI Switch
If the remote controller is to be used
with a Super Multi or Modular Multi
2-pipe system, then move the selector
switch to 'MULTI'. This will disable
'AUTO' and 'DRY' modes.
Downloaded from www.Manualslib.com
12/1/01
GB

Names and Functions of Controls

1. START/STOP Button
Push button to start operation.
(A receiving tone is heard.)
Push button again to stop operation.
(A receiving tone is heard.)
1
If no receiving tone is heard from the
indoor unit, push the button again.
2. Temperature L M Buttons (TEMP)
L
The set temperature is
Up increased to 30°C.
M
The set temperature is
Down decreased to 17°C.
(A receiving tone is heard).

REMOTE CONTROLLER

Slide downwards
to remove cover
4 4
manuals search engine
11:04 am Page 4
4
5
3
8
7
1. Infrared signal emitter
Transmits a signal to the indoor unit.
2. START/STOP Button
Push button to start operation.
2
(A receiving tone is heard).
3
Push button again to stop operation.
(A receiving tone is heard.)
If no receiving tone is heard from the
indoor unit, push the button again.
3. Mode select (MODE)
Push this button to set the operating mode
of air conditioner.
(A receiving tone is heard.)
4. Temperature L M Buttons (TEMP)
1 L
The set temperature is
Up increased to 30°C.
M
The set temperature is
Down decreased to 17°C.
(A receiving tone is heard.)
GB
Names and Functions of Controls
5. Fan
1
Push this button to select fan speed.
When you select AUTO, the fan speed is
automatically adjusted according to the
room temperature. You can also
manually select the fan speed from
( )
three settings .
2
(A receiving tone is heard.)
6
6. Auto Louver (CHR/KHR/UHR only)
9
Push this button to swing louver.
10
(A receiving tone is heard.)
Push this button again to stop louver
11
swinging.
(A receiving tone is heard.)
Slide cover
downwards
to reveal the
7. Off Timer Button
concealed
buttons
Push to allow the (OFF) time to be set.
8. On Timer Button
Push to allow the (ON) time to be set.
9. Time Adjust L M Buttons
L
Increases time.
M
Decreases time.
Used to set clock and ON/OFF times.
10. CNL Cancel Button
Push to cancel on/off timer.
(A tone is heard.)
11. RSV Reserve Button
Transmit times from remote to
indoor unit.
Push to set timer setting.
(A tone is heard.)
5