Assembly; Ventilation - BEAUTY ANGEL CVT 32 Gebrauchsanweisung

04/2014
Downloaded from www.Manualslib.com
2.6.1
Information regarding the disassembly and assembly of the device is availa-
ble in the separate assembly instructions. These assembly instructions are
intended solely for use by the manufacturer's service personnel or by qualified
specialists authorized by the manufacturer.
2.6.2
1506529-00A
manuals search engine

Assembly

DANGER!
Personal danger due to electric shock or burns!
– The assembly and electrical connection must comply
with the national regulations.
– The on-site electrical installation must be fitted with an
easily accessible all-pole isolating device (master
switch), complying with overvoltage category III. This
means that each pole must have a contact opening
width complying with the conditions of overvoltage cat-
egory III for full isolation.
– If the connection is established via a plug-in connection
then the connection system according to EN 60309
must be utilized.
– Assembly, installation, upgrading or repair of the device
may only be carried out by specially trained and in-
structed personnel.

Ventilation

WARNING!
Risk of overheating due to air flow problems!
Operating faults possible.
– Do not change, obstruct or block the air inflow and
outflow to the device or make any unauthorized chang-
es to the device. The manufacturer shall bear no liability
for damage or injuries resulting from such actions.
– Observe the ventilation system data.
– Do not set up and operate the device on the transport
pallet!
Data regarding the air supply and ventilation planning is available in the
planning manual (www.ergoline.de, available in English and German). You
can also obtain this data from your dealership or the customer service de-
partment (see page 2).
Information for the operator
Operating instructions – 9/52