Herunterladen Inhalt Inhalt Diese Seite drucken

Nice FT210 Anweisungen Und Hinweise Für Den Installateur Seite 12

Optical device
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 45
5.3) Example of connection of FT210 to control
unit with ALT input with constant resistance at
8.2kohm
If the control unit has an ALT input with constant
resistance of 8.2kohm , place a 8.2kohm resistance
in series with the two contacts PHOTO and ALT of
the receiver as shown in figure 29
5.4) Signals
The FT210 receiver has various LED signals (see figure 30)
that give luminous signals based on the operational status.
Table 5: Signals
LED L (red)
2 short flashes
Pause
2 short flashes
LED L1 (red)
Regular flash
On
4 short flashes
Pause
4 short flashes
5 short flashes
Pause
5 short flashes
7 short flashes
Pause
7 short flashes
LED L2 (yellow)
On
Off
LED L3 (red)
On
(ALT contact: open)
Off
(ALT contact: closed)
LED L4 (green)
On
(ALT contact: closed)
Off
(ALT contact: open)
Downloaded from
www.Manualslib.com
Cause
TX flat battery signal.
Cause
The rate of the flash indicates the quality of
the reception: the slower the flash the
greater the reception.
No signal, The "PHOTO" contact remains
open.
The transmitter is in the SLOW mode.
The receiver receives interference from
unrecognisable infrared signals.
The receiver receives the signal from a sec-
ond FT210 transmitter.
Cause
Signals an error during the test at the
beginning of the manoeuvre and the trans-
mitter changes over to the FAST mode.
The test at the beginning of the last
manoeuvre was correct.
Cause
The sensitive edge that is connected to the
transmitter is active.
The sensitive edge connected to the trans-
mitter is not active.
Cause
The sensitive edge connected to the trans-
mitter is not active.
The sensitive edge connected to the trans-
mitter is active.
manuals search engine
PHOTO
ALT
ALT1
29
30
Replace the transmitter battery as soon as possible
with another of the same type.
Everything Ok if the flash is slow: maximum 3 per
second, otherwise the alignment of the TX and RX
must be checked.
Remove the obstacle or improve the TX and RX
alignment.
Everything Ok if the gate is not moving.
An unknown transmitter is sending a signal towards
the receiver, try to remove the interference; check
the alignment of all devices present.
Eliminate the second transmitter. Two FT210 trans-
mitters cannot be positioned in the same area.
Connection or programming of the PHOTOTEST
input error. Possible poor functioning of the move-
ment sensor.
Everything Ok
Check the reason the edge was activated.
Everything Ok
Everything Ok
Check the reason the edge was activated.
ALT
COM
PHOTOTEST
PHOTOTEST
0Vac/dc
24Vac/dc
Action
Action
Action
Action
Action
12

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis