Comparator Results; Activating / Deactivating The Comparator Function - Chauvin Arnoux C.A 6630 Bedienungsanleitung

English
•
To programme the parameters of the next comparator, repeat steps 3 & 4 of the
procedure above.
To exit from the parameter set mode, press the SET key.
5.3
Interpreting the comparator results :
Voltage
Low value
high voltage
limit
High value
5.4
1. press SET to activate the comparator function. COMP is displayed, indicating
that the comparison will be made once the measurement has been carried out.
2. the comparator used is the last one selected before the instrument was last
switched off. To select another one from among the 99 possible, press
3. to activate the warning beep accompanying the WARNING and FAIL ratings of
the comparator, press
deactivate it, press
4. to deactivate the comparator function, press SET again.
Downloaded from www.Manualslib.com
6th press: high voltage limit – the last 2 digits flash
- use the &

COMPARATOR RESULTS

Resistance
Low value
WARNING LED +
beep
Warning !
PASS LED
Battery OK !

ACTIVATING / DEACTIVATING THE COMPARATOR FUNCTION

and .
manuals search engine
keys to set the values of these 2 digits
Low resistance limit
intermediate value
WARNING LED +
beep
Warning !
WARNING LED +
beep
Warning !
. This same symbol appears on the display unit. To
again.
33
Battery Tester C.A 6630
High resistance limit
high value
FAIL LED + beep
Battery Not OK!
FAIL LED + beep
Battery Not OK!