AEG BP630302I Benutzerinformation Seite 11

Clock function
6.2 Setting the DURATION or
END
1. Set an oven function.
2. Press
3. Press
For Duration
and then the hours, for End
set the hours and then the minutes.
An acoustic signal sounds for 2 minutes
after the time ends.
and time setting flash in the display. The
oven stops.
4. Press any button to stop the acoustic
5. Turn the knob for the oven functions
6.3 Setting the MINUTE
MINDER
1. Press
Downloaded from www.Manualslib.com
END
Press again and again to
switch between the clock
functions.
To confirm the settings of
the clock functions, press
or wait 5 seconds for an
automatic confirmation.
again and again until the
display shows or
or flashes in the display.
or to the set the values
and press to confirm.
first you set the minutes
or
signal.
to the off position.
If you press when you set
the hours for DURATION
, the appliance goes to
setting of the END
function.
.
manuals search engine
Application
To set when the appliance must deactivate. Use only
when an oven function is set. You can use Duration and
End at the same time (time delay), if the appliance is to
be activate and deactivate automatically later.
and "00" flash in the display.
2. Press
MINDER.
First you set the seconds, then the
minutes and then the hours.
At first, the time is calculated in
minutes and seconds. When the time
you set is longer than 60 minutes, the
symbol
The appliance now calculates the time in
hours and minutes.
3. The MINUTE MINDER starts
automatically after five seconds.
After 90% of the set time, an acoustic
signal sounds.
4. When the set time ends, an acoustic
.
signal sounds for two minutes.
"00:00" and
Press any button to stop the acoustic
signal.
first you
symbol
6.4 Count Up Timer
Use the Count Up Timer to monitor how
long the oven operates. It is on
immediately when the oven starts to
heat.
To reset the Count Up Timer, press and
hold
up again.
ENGLISH
or to set the MINUTE
comes on in the display.
flash in the display.
If you set the MINUTE
MINDER when the
DURATION or END
function operates, the
symbol comes on in the
display.
and . The timer starts to count
The Count Up Timer cannot
be used with the functions:
Duration , End .
11