Thera Trainer VEHO Erstinbetriebnahme Anweisung Seite 12

14 ADJUSTING DEVICE BASE
To increase stability of the THERA-Trainer veho adjust device base as follows (e.g. device base with
transport castors

Tilt THERA-Trainer veho over back edge.

Loosen clamping screws with a suitable tool.

Pull out device base no futher than the STOP mark (12 cm).

Tighten safety screws.

Tilt THERA-Trainer veho to the front.
Use rubber buffers to compensate any unevenness of the floor as follows (not for device base with height
adjustment and device base flat):










Loosen lock nuts 1 with a suitable tool.

Set height of rubber buffers 2 on device so that THERA-Trainer veho is stable.

Tighten lock nuts.
Requirements to place of installation:

Do not use THERA-Trainer veho in wet, humid or hot environment.

Put THERA-Trainer veho and chair/wheelchair on even and slip-proof floor.

Do not use THERA-Trainer veho outdoors.

Environmental conditions:
- 5 °C to 40 °C
- 15 to 90 % Rh
- 700 to 1060 hPa

Use THERA-Trainer veho exclusively with correctly set supply voltage.
12
Downloaded from www.Manualslib.com
THERA-TRAINER VEHO
INITIAL OPERATION INSTRUCTION

adjustment works the same for all device bases):
manuals search engine
1
2
Art. No.: A004-069_Rev 03
Last edit: CW07/2017