Siemens SITRANS LR 300 Schnellstartanleitung Seite 8

Quick Start Programming: steps 1, 2 and 3
Notes:
•
•
•
1.
2.
P001 Operation: Sets the type of
measurement required for the application.
Values
P002: Material
Value (view only)
P003 Measurement Response: Determines
level change reaction.
Values
Page EN-6
Downloaded from www.Manualslib.com
P000 locks the unit. The unlocking value is 1954: all other values lock the unit.
Default settings in the tables below are shown with an asterisk.
Please refer to the full Instruction Manual to set up inputs, communications, and other
functionality.
Configure all parameters to their factory settings via P999 Master Reset:
to activate PROGRAM mode.
a. Press
b. Press twice to access parameter fields.
Key in 999.
c.
d. Press to Clear All and initiate reset.
e. Reset complete. (Note: Reset takes several seconds to complete.)
Set the following parameters for a Quick Start:
1 Material Level
2 Space
3 * Distance (flange face to material)
1 * Liquids or slurries
1 Slow 0.1 m/min
2 * 1 m/min
3 10 m/min
4 100 m/min
5 Fast 1000 m/min
SITRANS LR 300 – QUICK START MANUAL
manuals search engine
P004 Antenna: Identifies antenna
configuration.
240 * factory setting for all antenna types
Val-
241 rod + 50 mm PTFE (Teflon) extension
ues
242 rod + 100 mm PTFE (Teflon) extension
P005 Units: Specifies units used for
dimensional values.
1 * Meters
2 Centimeters
Values
3 Millimeters
4 Feet
5 Inches
P006 Empty: Distance in Units (P005) from
flange face to process empty point.
Range: 0.000 to 9999
Values
Preset:10 m (or equivalent depend-
ing on units)
(Empty level can be set at any distance
desired, not just actual empty.
P007 Span: Sets the range levels to be
measured.
Range: 0.000 to 9999
Values
Preset: 10 m (or equivalent depend-
ing on units)
(Full level can be set at any measurement
above the empty level.)
)
7ML19985QA82