Program Mode - Siemens SITRANS LR 300 Schnellstartanleitung

Local Programming
The hand programmer is used for local programming sequences. Hold the programmer close
to the unit (within 15cm [6"]), and point it directly at the bottom of the display to activate the
programming options
display
max. 150 mm (6")

PROGRAM Mode:

The PROGRAM key
The EDIT icon
ENTER key
Switching from RUN to PROGRAM mode:
Accessing a parameter: scroll to the parameter number, or follow these steps:
1.
2.
3.
Note:
Changing a parameter value:
1.
2.
Resetting an individual parameter to Factory Setting
1.
2.
3.
4.
7ML19985QA82
Downloaded from www.Manualslib.com
.
hand
programmer
toggles between RUN and PROGRAM mode.
appears when you key in a new value: it remains visible until you press the
and the new value is accepted.
Press to activate PROGRAM mode: the number fields go blank.
Press to display the Parameter Number field.
Press again to open the Parameter Number
field. The field goes blank and the EDIT icon
appears
Key in the desired parameter number:
Example: . The new parameter
number and value appear.
Values shown are for demonstration purposes only.
Key in the new value. (The new value and the EDIT icon
Press to set the value. The EDIT icon disappears.
Scroll to the parameter or key in its address.
Press
.
The value field goes blank and the EDIT icon
Press . The value returns to factory default and the EDIT icon disappears.
SITRANS LR 300 – QUICK START MANUAL
manuals search engine
Key Programming Mode
Clear value
Toggle between Units and % on parameter value
Toggle between PROGRAM and RUN mode
Update echo quality parameters
Parameter scroll-up
Parameter scroll-down
Toggle fields
Enter the displayed value
appears.
parameter value
parameter
number
edit icon
appear.)
Page EN-5